Publicidad
INSTALLATION INSTRUCTIONS
FIXTURE PACKING LIST
DESCRIPTION
1.
Rear Housing
2.
Diffuser Door
3.
Diffuser Screws
4.
Wire Nuts*
* Contained in parts packs
Mounting hardware NOT included
Silicone Sealant required - Purchase Separately
REQUIRED TOOLS
1. Remove fixture components and parts pack. Check that all parts are
included.
DO NOT AIM UP. NOT FOR MOUNTING INVERTED OR ON CEILING.
2. Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power.
3. Loosen two Diffuser Screws (2) and open Diffuser (1).
Note: O-Rings will hold the screws captive.
4. Remove the Reflector
Remove reflector by loosening both Reflector Screws enough to allow
Reflector to slide upward (do not remove Screws completely). Once
the two screws slide into the keyhole slots, the Reflector will release
from the fixture housing and can be removed.
5. Remove appropriate knock outs
Look at back of rear housing to locate the pre-cast locators that
match most standard junction box mounting locations for junction box
mounting, or the pre-cast locators which allow for lag-bolt surface
mounting for conduit mounting. To remove the desired knock out either
drill through the knock out or carefully use a hammer and punch.
6. Install Fixture
Remove appropriate threaded plug for wire entry. Apply silicone
caulking to back of housing and thread house supply wires through
hole into fixture. Align fixture back against mounting surface and
QUANTITY
mount securely ( (mounting hardware not included) Note: Assure that
1
fixture is mounted onto structurally sound surface and use mounting
1
hardware appropriate for your application.
2
3
For Wet Location compliance, fixture must be properly sealed! For
moisture seal, apply silicone caulking between the mounting surface
and Housing back as well as around sides of Housing.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off.
7. Connect supply wires
Use Wire Nuts (9) to connect the black fixture wire to the black power
supply wire and the white fixture wire to the white (neutral) supply wire.
8. Replace Diffuser and tighten screws to secure.
9. Turn on electricity at fuse or circuit breaker box and verify success of
installation.
10. Make sure all wiring access holes are sealed with weatherproof
silicone sealant (not included).
Trouble Shooting Guide
If this fixture fails to operate properly, use the guide below to diagnose
and correct the problem.
• Verify that power is turned on at switch and breaker
• Verify that fixture is wired properly
• Verify that line voltage is correct.
If further assistance is required, contact Technical Support.
This LED light provides low maintenance service with no bulbs to change.
Clean surfaces with a mild soap and water. Do not use abrasive materials
such as scouring pads or powders, steel wool or abrasive paper.
WARNING: There are no user serviceable parts inside lamp head. Do not
remove or disassemble lamp head. This will void Warranty.
For proper connection, place wire nut over wires
and twist clockwise until tight.
Publicidad
