Installation - Wireless Doorbell - HAMPTON BAY HB-7622-03 Guía Para El Uso Y Cuidado

Installation - Wired Doorbell (continued) Installation - Wired Doorbell
5
Installing the diode
NOTE: The doorbell will not play the entire musical
tune and the "TUNE" button will not work if a diode is not
installed on the main push button.
If a diode (CC) is not already installed on a
push button, loosen the two wiring screws on
the back of the existing push button and wrap
each of the ends of the diode (CC) around each
screw. Tighten the screws onto the diode (CC)
and wiring.

Installation - Wireless Doorbell

1
Installing the batteries
NOTICE: When using this doorbell with a transformer, batteries are
not needed and should not be installed even when using wireless
push buttons.
If the doorbell is not connected to transformer
wires, install 3 alkaline "C" batteries (not
included) into the doorbell base (B). Make
sure batteries are installed according to the
diagram inside the chime
Syncing the doorbell and push
2
button
Press and release the "SYNC" button on the
doorbell base (B).
Press the push button within 30 seconds.
The doorbell base (B) will play a "Beep-Beep" to
indicate the push button is synced.
Press and release the push button to verify the
doorbell base (B) and push button are synced.
Testing the doorbell and push
3
button placement
Temporarily position the doorbell base (B) and
push button where they will be mounted.
Press the push button and listen for the doorbell
to ring.
If the doorbell does not sound, move the
doorbell closer to the push button and test
again.
CC
NOTE: In typical use, alkaline batteries will last up to
one year.
SYNC – PRESS
AND
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
30
NOTE: Do not permanently mount the push button or
doorbell base (B) until they are working properly.
6
CC
RELEASE.
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.
B
B
B