NuTone SENSONIC MS-825 Manual De Instrucciones página 3

In other words, the sound to the rear speakers can be delayed
with respect to the front speakers to create the effect of
vastness of space. In most A/V receivers, this delay can be
controlled depending on personal taste. Usually in the Pro
Logic mode, this delay is controllable between 15-30
milliseconds.
For best sound imaging, place the center channel speaker
MS-725 above or below your TV in line with your main front
left and right channel speakers, and aim it directly at the
audience. Placing it beside the TV may not result in coinciding
the sound and picture, which is very important for optimum
surround effect.
MS-725 has one surface of the cabinet which is sloping.
Hence, if you place it below your TV, you can tilt it upwards to
face the audience. If you place it above the TV on its flat
surface, you can direct sound straight out to the audience.
A more elaborate sound system can be made by adding
MS-418 sub-woofer to enhance the bass frequency
reproduction. Placement of MS-418 in a room is not critical
since it primarily reproduces low frequency sounds, which are
non-directional. Place the sub-woofer in any convenient
location commensurate with your aesthetic and listening
preferences.
Cross-over network
(Overload protector not shown)
MS-825, MS-828 IN-WALL SPEAKER
Grille
FEATURES
MS-825
• 5 1 ⁄ " woofer with polymica cone and butyl rubber surround
4
and 3 ⁄ " Titanium swivel dome tweeter with ferrofluid cooled
4
ferrite magnet
• Impedance: 8 Ohms
• Power handling capacity: 80 watts
• Frequency Response: 40-23,000 Hz +/- 3 dB
• Sensitivity, 1 m @ 1 W: 86 dB typ.
• Protection: Tweeter overload protected by self-reset
polyswitch
MS-825K
• A pair of above speakers with a pair of IR-906 metal
rough-ins, for use in existing construction
MS-828
• 8" woofer with polymica cone and butyl rubber surround
and 3 ⁄ " Titanium swivel dome tweeter with ferrofluid cooled
4
ferrite magnet
• Impedance: 8 Ohms
• Power handling capacity: 120 watts
• Frequency Response: 35-23,000 Hz +/- 3 dB
• Sensitivity, 1 m @ 1 W: 88 dB typ.
• Protection: Tweeter overload protected by self-reset
polyswitch
MS-828K
• A pair of above speakers with a pair of IR-909 metal
rough-ins, for use in existing construction
+3 dB
0 dB
Tweeter mounting plate
Tweeter level control
(Slide up to increase level by 3 dB)
Swivel dome tweeter
(Press around the edge to swivel)
Enclosure
Woofer
Woofer dust cap
Woofer mounting screws
(Do not remove)
Speaker mounting holes
(Use for installation)
FIGURE 1