Karel MS48 Quick Start Guías página 5

II.1 H
ANGING THE SYSTEM ON THE WALL
1) Place the template on the wall to select the proper location for the system.
2) Drill two holes as shown on the template, place the screws and hang the system through the pear holes
at the back of the cabinet.
II.2 I DY26
NSTALLING
1) Hang the doorphone on the wall.
2) Pass the free end of the cable through the cable hole at the bottom part of the system cabinet.
3) Insert the 4-pin plug into the Doorphone socket (X3) on the motherboard (see Figure 1).
II.3 I CM48-W
NSTALLING
To install the hardware:
1) Insert the pin connectors of the card into the A1-A3 connectors on the motherboard (see Figure 1).
2) Pass the pin connector end of the cable through the cable hole at the bottom part of the cabinet.
3) Insert the pin connector into the socket on the PKCR or RS232 card.
4) For the PKCR card, connect the 25-pin D-type plug to the security plug and the security plug to the PC.
For the RS232 card, connect the 25-pin D-type plug to your serial printer.
To set up the CM48-W /PK48-D software on the PC:
1) Insert the diskette into the PC.
2) Run INSTALL.EXE file in the diskette and follow up the prompted commands.
NOTE: Using a single PKCR card, a cable and a security plug, you can set up both the CM48-W and PK48-D
programs on the PC.
II.4 I EVM48
NSTALLING
1) Remove the screw S4 on the motherboard and fix the brass card holder instead (see Figure 1).
2) Insert the pin connectors of the card into the B1-B3 connectors on the motherboard (see Figure 1). Then fix the
screw to the brass card holder to fix the card.
To install optional EVM-FE (Auto Attendant Expansion Module) or EVM-DE (Voice Mail Expansion Module):
1) Insert the pin connectors on the EVM-FE / EVM-DE card to the male ones on the EVM48 card (see Figure 2).
EVM48
Figure 2 - Installation of EVM-FE and EVM-DE
4
/ PK48-D
AND OR OR
Optional
EVM-FE
F1 F2 D3
RS232
Optional
EVM-DE
D2 D1