Intesis INWMPPAN001R000 Manual De Instalación

Interface INWMPPAN001R000
Safety instructions
WARNING
Follow carefully this safety and installation instructions. Improper work may lead to serious harmful for your health and also may damage seriously the
interface and/or the AC indoor unit.
• This interface must be installed by accredited technical personnel (electrician, installer or authorized technical personnel) and following all the
safety instructions.
• This interface must only be installed in a restricted access location.
• Before manipulate the AC indoor unit be sure it is completely disconnected from Mains power.
• In case of installation of the interface inside the AC indoor unit, fix the interface and communication cables preferably to any appropriate point of
the plastic cover of the unit taking care of no blocking free movement of mobile parts and as far as possible from tubes containing liquids and power
cables.
Installation instructions
1.
Unplug the Panasonic system from mains electricity.
2. Connect Intesis device RC port to Panasonic's Indoor Unit R1R2 terminals (no polarity on RC connector).
3. Connect Wired Remote Control in parallel to R1R2 bus (if present).
4. Configure the Intesis switches (see below).
5. Plug the Panasonic system to mains electricity.
1. Wi-Fi Access Point or Router
2. Intesis device
3. Wired Remote Controller
4. Indoor unit
4.
1
Switch configuration
Binary value Switches
Decimal
value
b ...b 1 2 3 4
0 4
0xxx 0  x x x
1xxx 1  x x x
x0xx 0 x  x x
x  x x
x1xx 1
xx0x 0 x x  x
xx1x 1 x x  x
xxx0 0 x x x 
xxx1 1 x x x 
SW3: This switch determines the performance of the device. Running in High Performance Mode means maximum consumption and maximum device performance.
SW4: This switch determines the Wi-Fi range of the device. Maximum range is set by default. Consider that changing this switch may affect to device WiFi communication,
happening a device in a running installation not to reach the current access point or Wi-Fi network to which is connected.
In case no external supply is used: In very specific installations, AC port consumption may be overpassed, leading the device to reboot. If that happened, decrease device
consumption by using SW3 and SW4.
NOTE: Remember that you need to power cycle the climate system or the Intesis device for the changes in the switches to be applied.
The User's Manual is available at:
https://intesis.com/products/ac-interfaces/panasonic-gateways/panasonic-ascii-wifi-vrf-pa-rc2-wmp-1
Rev.1.0
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
Important: If a wired remote controller of the AC manufacturer is connected in the same bus, communication may shut down. In
case it happens, use an external power supply connected to the PS connector in our device to overcome this situation.
Connect a NEC Class 2 or Limited Power Source (LPS) and SELV rated power supply to the device, respect the polarity.
Apply always a voltage within the range admitted and of enough power (12V DC, min. 100 mA).
Description
Follower in R1/R2 bus. Wired remote controller needs to be set as header. (Default Value)
Header in R1/R2 bus. Wired remote controller needs to be set as follower.
Temperature in Celsius (in the RC bus) (Default Value)
Temperature in Fahrenheit (in the RC bus)
Low Power Mode
High Performance Mode (Default value)
Wi-Fi power is limited
Max Wi-Fi power (default value)
4
2
Installation Manual
OPTIONAL
3
R1/R2 BUS
URL https://www.intesis.com
R1/R2
connector
1 / 2