Fan Assembly. Pgs - Ellington Elevating Style E-BLD52AN5C1 Guia De Instalacion

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet
box and able to support the fan, you are now
ready to hang your fan. Grab the fan firmly with
two hands. Slide downrod through opening in
hanging bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball slot until
it lines up with the hanging bracket tab.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to "Wiring" section for wiring diagram.
6. Fan Assembly (flushmount).
Remove canopy cover and set aside to reveal
6 holes. Notice that 3 of the holes are larger
than the others.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph.
If there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Remove pin and clip from motor housing
yoke. Thread wiring through canopy. Place
canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of
motor housing. Insert the 3 screws and 3
lock washers that were removed (if there
were only 3 screws located in top of motor
housing, these screws/lock washers will be
located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy
to do so.)
clip
page 5
hanging bracket tab
hanging ball slot
canopy
canopy cover
canopy
motor housing
canopy
hanging bracket tab
motor housing
pin
yoke