Introduction; Description; Wm100 Receiver - PROEL WM100 Manual De Usuario

INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The WM100 Wireless Microphones series is a VHF, quartz controlled, fixed frequency device, which provides
a reliable, high quality signal transmission.
WM100 Wireless Microphone system features 3 units: WM100 receiver, WM1M handheld transmitter and
WM1H body pack transmitter. The system is available in three different configurations, each of them
including an ABS carrying case:
WM100M : WM100 + WM1M
WM100H : WM100 + WM1H + lavalier + headset
WM100KIT : WM100 + WM1M + WM1H + lavalier + headset
Six factory pre‐build frequencies are available, which have been accurately selected to allow the
simultaneous use of 6 devices without interference between them:
1. 191.900 MHz
2. 185.150 MHz
3. 197.150 MHz
4. 200.175 MHz
5. 201.400 MHz
6. 211.500 MHz
WM100 RECEIVER
See FIG. 1 at page 15:
1. DC IN
Socket for the AC/DC adaptor connection, use only the adaptor supplied with the system.
2. OUTPUT (UNBALANCED)
Unbalanced audio output with line level: connect it through a mono 6.3mm jack cable to a mixer input.
3. OUTPUT (BALANCED)
Balanced audio output with mic level: connect it through a XLR cable to a mixer input.
4. POWER
On/off switch.
5. ON
Red LED: if lighted states that the power supply is present and the receiver is turned on
6. RF
Green LED: if lighted states that the transmitter is sending a radio signal to the receiver.
7. VOLUME
Volume potentiometer: set this control to a proper level that doesn't saturate the mixer input channel.
8. ANTENNA
These are the receiving antennas. Raise them up during the use and, to obtain a better reception, place
the receiver away from other metal objects and no more distant than 30m from the transmitter.
9. RECEIVING FREQUENCY
In this label, together with the general data of the receiver, you can find the receiving radio frequency.
6