Fuse Replacement - VWR AU Manual De Instrucciones

FUSE REPLACEMENT

A Mains inlet is located on the Rear Panel incorporating twin mains fuses FS1 and FS2.
Under normal operating conditions these fuses should not require replacement. In the
event of fuse failure a replacement fuse should be fitted, its value as stated in the
specification. Qualified personnel should investigate repeated fuse failure.
U.K. only - The mains lead supplied with U.K. models incorporates a 3 pin 13 amp plug
fitted with a 5-amp fuse.
MAINTENANCE
Motor and Gearbox are lubricated for life and should not require attention. Rotor rollers
are self-lubricating. Should lubrication become necessary use Silicone grease on rollers
if noisy. If the motor gearbox should require lubrication authorized personnel should
carry this out.
Pump tubing will not last forever, establish suitable tube replacement schedule to
prevent inconvenient tube failure.