Range Hood Care - Frigidaire LI30KC Manual De Usuario

RANGE HOOD CARE

Cleaning
WARNING
To Reduce The Risk Of Fire Or Electrical shock
disconnect from power supply before cleaning.
IMPORTANT
Clean the hood and grease filters frequently
according to the following instructions. Replace
grease filter before operating hood.
IMPORTANT
Exterior Surfaces
Do not use soap-filled scouring pads, abrasive cleaners,
Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use
cleaners that contain chlorine.
Cleaning Method:
Use warm water with liquid detergent or all purpose
•
cleaner and soft cloth to clean outside surfaces.
Rinse with clean water and dry with soft, lint-free cloth.
•
Use glass cleaner to remove fingerprints.
•
For stainless steel finish rub in direction of grain to
•
avoid scratching or damaging the surface.
NOTE: On stainless steel finish, clean in direction of
stainless steel brush to avoid scratching or damaging
the surface.
To clean or replace grease filter:
1.
Remove screw from the plastic filter retainer clip with
phillips screwdriver
. Turn the filter retainer to release filter.
A
. Reinstall the filter by placing the back edge in the
channel at rear of hood. Push filter into place, turn
the filter retainer to secure filter to range hood.
14
A. Filter screw
4. Replace screw in the filter
retainer.
.
To clean grease filter, soak
the filters in hot water using
a mild detergent. Rinse well
and shake to dry. Or place
in upper rack of dishwasher
to clean.
NOTE: Do not use ammo-
nia. The aluminum on the grease filter will corrode and
darken.
NOTE: You can use either dishwasher or hot detergent
solution and rinse in clean water.
NOTE
The grease filter is dishwasher safe.
To avoid grease filter damage while cleaning,
place filter into the dishwasher top rack for
cleaning
Replacing the Incandescent LightBulb
1.
Turn off the range hood and allow the light bulb to cool.
.
Disconnect power - Turn off house breaker at breaker box.
. Squeeze the plastic lens cover and remove it from the hood.
4. Screw a 75W max, 120V
incandescent light bulb
into socket.
. Replace lens cover by
squeezing cover and
inserting tabs into
slots.
. Reconnect power.
If new light does not operate, make sure the lamp is
inserted correctly before calling service.
B
A
Charcoal / Grease Filter Accesory Kit
For recirculating vent hood, an optional charcoal filter is
available. You can order this as part number 5304486302.
The charcoal filter is not washable. It should last up to 6
months with normal use.
Replace the old charcoal filter with a new charcoal filter.
A
A. Filter screw
A. Light bulb socket
B. Lens cover