Casals HA150032QEAK Manual De Usuario página 6

- Only use the appliance for carrying out dry
tasks.
- Make periodical checks on the sealing ring,
- Do not use the appliance on any part of the
body of a person or animal.
- If the application tool should become
blocked, switch the machine off. Loosen teh
application tool.
- Before switching on the power tool, make
sure that the application tool moves freely.
When switching on with a blocked drilling tool,
high torque reaction can occur.
- Always hold the body handle and side han-
dle of the power tool firmly. Otherwise the
counterforce produced may result in inaccu-
rate and even dangerous operation.
- Let the appliance running with no load for
30 seconds in a safe position. If you notice
serious vibration or other defects stop the ap-
pliance immediately. Then check the problem
and /or proceed as we describe on Anomalies
and Repair clause.
- The appliance can be used on surfaces such
as: wood, cardboard, plastic, plaster, etc.
- Use suitable detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance. Contact
with electric lines can lead to fire and elec-
tric shock. Damaging a gas line can lead to
explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
- Do not touch the bit during or immediately
after operation. The bit becomes very hot dur-
ing operation and could cause serious burns.
- Do not use the power tool with a damaged
cord. Do not touch the damaged cord and pill
the plug
Warning: Reduce the working time to avoid
risks related with too much vibration.
6
Product description and Specifications
Description
A- SDS Plus Chuck
B- Bit Holder ring
C- Rotary stop Lever
D- Drilling/hammer drilling switch
E- On/Off Switch
F- Auxiliary handle
G- Grease cover
H- Electronic regulation control
I- Dust collector
J- Drill Chuck
K- SDS-plus adaptor
If the model of your appliance does not have
the accessories described above, they can also
be bought separately from the Technical Assis-
tance Service.
Installation
Auxiliary Operation (Fig 1)
- Operate the appliance only with the auxiliary
handle.
- Turn the auxiliary handle (F) in clockwise.
- Set the auxiliary handle on the appliance into
the required position.
- Tighten the auxiliary handle (F) in counter
clockwise direction.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Prepare the appliance according to the func-
tion you wish to use:
Fitting the working tools: (Fig. 1, 2)
- Unplug the appliance from the mains.
- Only use tools with SDS-plus shaft.
- Clean and grease the shaft of the tool.