BEARWARE 303717/20200115HK016 Manual página 25

5.1 Connection with the outdoor sensor
1. Select the desired channel using the "Channel" button in the battery com-
partment of the outdoor sensor.
2. After being switched on, the weather station attempts to connect with the
outdoor sensor. Ensure that both devices are within each other's range. The
connection icon "
of the main unit. To start scanning automatically, press the "Sensor" button
on the back of the device.
If the main unit cannot establish a connection with the outdoor sensor within 2
minutes, then it stops searching. The connection icon stops flashing and the tem-
perature display shows "--%" and "--.°C" on the display.
If a connection cannot be established, then this could be, for example, due to thick
walls, or to a long distance of the sensor from the main unit. In this case, positi-
on the sensor and the main unit closer to each other. To restart scanning, press
and hold the "Sensor" button on the back of the main unit for 2 seconds until the
connection symbol in the display starts flashing.
If the outdoor sensor signal is interrupted and the connection cannot be restored
within an hour, then the display shows "Er" (error) in the temperature and humi-
dity display. If the signal is still not available after 48 hours, the display shows "Er"
permanently. Press the "Sensor" button on the back of the device to reconnect
the device.
6. Basic settings
Note: When the backlight is switched off ("backlight" switch in Off position), the
backlight can be turned on for approximately 5 seconds by pressing the large
"SNOOZE / LIGHT" button at the top of the housing.
Press and hold the "TIME SET" button for about 3 seconds to modify the basic
settings. With the "CHANNEL/+" and "MEM / _ " buttons you can change the
values accordingly.
By briefly pressing the "TIME SET" button, you can confirm the entry and proceed
to the next option. In this way, you can change and customise the following
settings in the sequence mentioned below:
• 12/24 hour format
• Hour
• Minute
English
" starts flashing in the "Outdoor temperature" display
25