Toparc RC-HD2 Manual Del Usario página 36

PARAMETERS
The display mode gives access to more or less welding parameters and configurations.
- Easy: display and reduced functionality: no access to the welding cycle.
- Expert: complete display, allows to adjust the duration and time of the different phases of the welding cycle.
- Advanced: full display, allows you to adjust all the parameters of the welding cycle.
The name of the device and the possibility of customizing it.
Supported languages: French, English, etc
The Units of Measurement: International (SI) or Imperial (GB/USA).
Naming material: EN (European) or AWS (USA)
Example: Fe (EN) -> Steel (AWS), CrNi 308 (EN) -> ER 308L (AWS)
Time, date and format.
Screen brightness
The cooling unit (AUTO / ON / OFF) and the PURGE function of the cooling unit:
- AUTO: activation during welding and deactivation of the cooling unit 10 minutes after the end of welding.
- ON: the cooling unit is permanently controlled.
- OFF: the group is disabled.
- PURGE
Product Reset (Partial / Total) :
- Partial (default value of the welding cycle).
- Total (factory configuration).
CALIBRATION
This mode is dedicated to calibrating the speed of motorized reels. The purpose of the calibration is to compensate for variations in the
reel speed in order to adjust the displayed voltage measurement and to refine the energy calculation. The procedure once launched is
explained with an animation on the screen.
This mode is also dedicated to the calibration of welding accessories such as torch, cable + electrode holder and cable + ground clamp.
The purpose of the calibration is to compensate for variations in accessory lengths in order to adjust the displayed voltage measurement
and refine the energy calculation. The procedure once launched is explained with an animation on the screen.
Important: The cable calibration must be repeated each time the torch, harness or ground cable is changed to ensure optimal welding.
PORTABILITY
This feature allows you to save the welding configuration of the machine.
It also allows you to load a recovered configuration on another machine and inject it into another.
36
: function dedicated to purging the cooling unit or filling beams, the protections are then inhibited.
RC-HD2 EN