Replacing The Nozzle; Maintenance And Cleaning; Ec Declaration Of Conformity - Würth HKP 220 Traducción Del Manual De Instrucciones De Servicio Original

Replacing the Nozzle

Caution: Danger of burning from the hot nozzle and
adhesive.
Heat up the glue gun.
Disconnect the glue gun from the mains supply by pull-
ing the mains plug.
Unscrew the nozzle 1 using heat-protection gloves. Do
not actuate the feed regulation button 6 when doing
this, in order to prevent uncontrolled leakage of adhe-
sive.
Screw on the replacement nozzle hand-tight. After-
wards, the glue gun can immediately be put into oper-
ation again.

Maintenance and Cleaning

 Before any work on the machine itself,
pull the mains plug.
 For safe and proper working, always
keep the machine and ventilation slots
clean.
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
viewed in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee in
accordance with the legal/country-specific regulations
from the date of purchase (verified by invoice or deliv-
ery document). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your Würth
sales representative or a customer service agent for
Würth compressed-air and power tools.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According to the European Guideline
2012/19/EU for Waste Electrical and
Electronic Equipment and its implemen-
tation into national right, power tools
that are no longer usable must be col-
lected separately and disposed of in an environmen-
tally correct manner.
EC-Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standarisation documents: DIN EN 55014,
DIN EN 60204-1, DIN EN 60335-1,
DIN EN 60335-2-45, DIN EN 61000-3 in accord-
ance with the Directives 2001/95/EC,
2002/95/EC, 2002/96/EC, 2006/95/EC,
2004/108/EC (19.04.2016)
2014/30/EU (20.04.2016).
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PCM
Reinhold-Würth-Straße 12 – 17,
74653 Künzelsau, GERMANY
Würth International AG
Aspermontstrasse 1
CH-7000 Chur
SWITZERLAND
Gerd Rössler
Managing Director
Chur: 08.02.2016
Subject to change without notice.
Patrick Kohler
Department Manager
Category Management
9