Erase All Transmitters In The Receiver; Repairs; Spare Parts - Husqvarna HTC D80 Manual De Usuario

HTC D80
4. Assemble the receiver's cover by fitting the cover and bottom together and
pressing them together; the heels on the sides lock into place.
To add further transmitters, repeat points 2-3.
6.6.4

Erase all transmitters in the receiver

1. Open the cover on the receiver.
2. Press the Learn/Erase button, until light emitting diode 7 shines. The Learn mode
is activated for 10 seconds. Figure 6-8, page 46.
3. Press the Learn/Erase button for 5 seconds (until light emitting diode 7 goes out).
All transmitters are now erased from the receiver's memory. Figure 6-8, page
46.
4. Replace the receiver's cover.
6.7

Repairs

Any repairs that may be required must be carried out by an HTC Service Centre that has
trained service personnel and uses HTC original parts and accessories. Contact your
retailer if your machine requires servicing. For contact information, see Contact
Information at the start of the manual.
6.8

Spare parts

To ensure rapid delivery of spare parts, always specify the model, the machine's serial
number and the spare part number when ordering. Information on the model and serial
number can be found on the machine's name plate.
Information on spare part numbers can be found in the machine's spare parts list which
is available to read or print out from the accompanying digital media or HTC's website:
www.htc-floorsystems.com
Only original tools and original spare parts from HTC may be used. Otherwise neither
the CE marking nor the warranty will be valid.
1.1
Service
47