Recommendations For Use - jbc ADVANCED Serie Manual Del Usuario

ENGLISH
SPECIFICATIONS
The DS 5300 is a repair station for desoldering
through-hole components by solder intake.
- DS 5300 230V
It is supplied with a DR 5600 desoldering iron
Advanced. Also all the Advanced soldering
handpieces, the tweezers and the AP 1300 solder
feed iron can be connected to the station.
The station's components
- DR 5600 desoldering iron
with the 5600-003 tip
- DR 8500 desoldering iron stand Ref. 0788500
- External desoldering air filter
- Spare filters
- Set of accessories
- Instruction manual
The DS 5300 station has the following
complementary products:
- 2210/2225 handpiece
- 2245 handpiece
- PA 1200 micro hot tweezers
- PA 4200 hot tweezers
- AP 1300 solder feed iron
These articles are not delivered with the station.
Control Unit technical specifications
- Input voltage: 230V 50Hz.
- Station's maximum power: 100W.
- Maximum power desoldering iron 75W.
- Temperature selection: 100 to 371°C (±5%).
- ESD protected housing.
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- Equipotential connector and the tool tip are
connected to station mains ground supply for
ESD protection.
- Weight of complete unit: 7 kg.

RECOMMENDATIONS FOR USE

For soldering and desoldering
-
Ref. 5300200
-
-
Ref. 5600000
Ref. 5600003
Safety measures
-
Ref. 0821830
-
Ref. 0781046
Ref. 0780593
-
Ref. 0780921
-
-
Ref. 2210000
Ref. 2245000
Ref. 1200000
Ref. 4200000
Ref. 1300000
5 -10 11 Ohms/
2
Clean the contacts and the printed circuit
to be desoldered of dust or dirt.
Preferably select a temperature below
350°C. Excess temperature may cause the
printed circuit tracks to break loose.
The tip must be well tinned for good heat
conduction. If it has been inoperative for
any length of time, it should be retinned.
Incorrect use of this tool may cause fire.
Be cautious when using the tool in places
where inflamable products are stored.
Heat can fire up inflamable products even
when they are not at sight.
Do not use when the atmosphere is
explosive.
Place the tool back on its stand in order to
let it cool down before you store it.