Haier HDBC100AFS Instrucciones De Instalación página 13

Option 2, No waste disposer - with air gap:
1. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp. If the drain hose was
cut, use a 11/2" to 2' (3.8 to 5 cm) screw-type clamp*.
3. Use a rubber hose connector* with spring or screw type clamps* to connect air
gap to disposer inlet.
This connection must be before the drain trap and at least 20" (50.8 cm) above the
floor where dishwasher will be installed.
*Parts available from local plumbing supply store.
Option 3, Waste disposer - no air gap:
1. Remove the disposer knockout plug. Do not cut end of drain hose.
2. Attach drain hose to disposer inlet with large spring-type clamp.
3. Use a rubber hose connector* with spring or screw type clamps* to connect
disposer inlet.
This connection must be before the drain trap and at least 20" (50.8 cm) above the
floor where dishwasher will be installed. It is recommended that the drain hose be
looped up and securely fastened to the underside of the counter.
* Parts available from local plumbing supply store.
Option 4, No waste disposer - no air gap:
1. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to waste tee with 11/2" to 2" (3.8 to 5 cm) screw-type clamp*.
drain hose –
cut here if needed
rubber hose
connector
spring or
screw-type
clamps
waste
tee
drain trap
large spring-type
clamp
disposer
inlet
drain trap
air gap
large
spring-type
clamp
drain
hose
drain hose
11