Campbell Hausfeld PA210200AV Manual Del Usuario

Operating Instructions and Parts Manual
Lubricator
Model PA210200AV
Description
Lubricators are designed to provide oil to the
air tool and increase the life of the tool from
compressed air flow up to 250 psig.
Unpacking
After unpacking the unit, inspect carefully for any
damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before
putting unit into service.
Read & Follow all InstRuctIons
save these InstRuctIons
do not dIscaRd
Safety Guidelines
This manual contains information that is very
important to know and understand. This information
is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this
information, observe the following symbols.
situation which, if not avoided, WILL result in death
or serious injury.
situation which, if not avoided, COULD result in
death or serious injury.
situation which, if not avoided, MAY result in minor
or moderate injury.
followed, may cause damage to equipment.
note: Information that requires special attention.
© 2012 Campbell Hausfeld/Scott Fetzer
Danger indicates an
imminently hazardous
Warning indicates a
potentially hazardous
Caution indicates a
potentially hazardous
Notice indicates important
information, that if not
For parts, product & service information visit
www.campbellhausfeld.com
Figure 1 - Pa210200av
Specifications
Temperature
Range . . . . . . . . . 40°F to 140°F
Maximum
Pressure . . . . . . . . . . . . . 250 PSI
Air Inlet/Outlet . . . . 3/8 inch NPT
Rated Flow . . . . . . . . . . 60 SCFM
Drain Capacity . . . . . . . 4 .2 fl . oz .
IN738800AV 9/12