Basic Operation - Alpine PXA-H600 Manual De Operación

1
10
Initial System Start-Up
When operating the unit for the first time after
installation or after the vehicle's battery has
been disconnected and reconnected, set the
volume level to its minimum, then press the
Reset switch with a ball-point pen or any other
pointed object.
Power On or Off
The unit is turned OFF or ON from the head
unit's Power switch.
Operating procedures for
use with non-Ai-NET Head
Units
Setting Input Level
Before operating the PXA-H600, the input level
from the head unit needs to be properly
adjusted. If proper adjustment is not made,
optimum Signal-to-Noise ratio cannot be
obtained. Following the procedures below will
ensure that optimum sound quality will be
OVER
achieved.
• Adjust the input level using the Volume
• After setting the input level, use the
• If the "OVER" indicator comes on when

Basic Operation

control on the head unit.
PXA-H600 to make any volume adjust-
ments. Whenever the input level becomes
excessive, the "OVER" (overrange) indicator
will flash in the display. To minimize
distortion and for the best possible sound,
adjust the input level so the "OVER"
indicator no longer flashes.
using a different source, repeat the above
procedure for the new source.
English