Whirlpool AMD 081/1 Instrucciones Para El Uso página 24

Sleep mode
Press Sleep button on remote control, the
appliance operates in sleep mode and the fan speed
is automatically set to low speed.
NOTES:
• In Cooling mode if the current room
temperature is 26ºC or higher the set
temperature will not change when Sleep mode is
activated, otherwise, the temperature will
automatically increase 1ºC during the first hour.
• The set temperature will not increase during the
last 7 hours in Sleep mode.
1. Press MODE to select Cooling or Dry.
NOTE: Sleep mode cannot be selected when Fan
Only is selected.
2. Press Fan button .
3. Press the or
temperature.
4. Press SLEEP . The On/Off indicator will flash for
10 seconds, and the lights on the control panel
display will dim after 5 seconds.
NOTES:
• The temperature and airflow direction can be
• To turn off Sleep mode, press MODE, ON/OFF,
Changing Air Direction
On Remote Control or Control Panel
Press SWING once to change vertical airflow
direction. Press again to stop airflow louver at
desired airflow direction.
Normal Sounds
When your air conditioner is operating normally,
you may hear sounds such as:
• Air movement from the fan.
• Clicks from the thermostat cycle.
• Vibrations or noise due to poor wall or window
button to set the
• A high-pitched hum or pulsating noise caused by
24
adjusted during Sleep Mode.
6th SENSE, JET or SLEEP again or wait 8 hours
for the air conditioner to turn off automatically.
construction.
the modern high-efficiency compressor cycling
on and off.