USRobotics 5454 Guía Breve De Instalación página 9

The locator lists the access point as well as any other USRobotics devices that
that were found:
4. Select the device whose MAC address matches the LAN MAC address on the
bottom of the access point, and click Next.
The locator displays the name, IP address, and LAN MAC address of the
access point.
5. Click Finish.
The locator launches the setup pages for the access point.
6. Follow the on-screen instructions to complete the initial setup of the access
point as follows:
A. Click Start.
B. Click
C. Click Continue.
D. Enter a User name and Password and click Finish.
N o t e : Remember the User name and password that you enter. You
will need it whenever you access the setup pages of the access
point.
The access point displays its Status page. If you intend to connect wire-
less devices to the access point manually, you will need the information
1 By default, SecureEasySetup is ready to be used on your access point. If you change the wireless
settings, be aware that for SecureEasySetup to be ready on your access point, it must be set with
WPA2 and WPA (PSK) wireless security, with TKIP and AES encryption, and a pass phrase
(which is also commonly called a Network key, WPA key, or WPA Pre-shared key). You can configure
the settings manually on the Wireless configuration page of the access point or automatically by
pressing the SecureEasySetup button on the back of the access point.
1
English
5