Boon FLAIR Instrucciones De Uso página 7

disassembly
If it should become necessary to disassemble your highchair
for transport or storage, please follow these instructions.
Tools required: Phillips screwdriver, flat-head screwdriver (not included)
1
Remove the two bolts that attach the seat base
cover to the seat.
4
Locate the metal spring tab attached to the center tube
of the base. Use the flathead screwdriver to gently pry
UP on the spring end of this tab, while at the same time
pulling the support tube out of the base. Note that it may
be easier to have two people perform this disassembly.
2
Raise tube to highest position by stepping on height
adjustment button. Remove the five bolts that attach seat
to support assembly.
5
Before storing or transporting chair, reattach gray
weight to highchair base. Position gray disc in center of
star with six raised bumps facing out. Reattach disc by
fitting tabs into holes in center of disc. Make sure tabs fit
snuggly in holes.
3
Tip the highchair on its side. Locate the large gray
weight in the center of the base and the two plastic tabs
that hold it in place. Use the flathead screwdriver to pry
one of these tabs toward the center hole of the weight
while at the same time pulling the weight slightly away
from the base. Do the same for the other tab to fully
release the weight.
W WARNING
• DO NOT disassemble any other
components of the highchair.
7