Raven B463 El Manual Del Propietario página 9

7. Locate the (2) support brackets, (2) long hex bolts,
(2) short cap screws and (4) hex nuts. Assemble as
shown. Use the long hex bolts on the bottom and the
short cap screws on top at the main frame. When both
brackets are installed, tighten these (4) fasteners, as
well as the (2) fasteners from Step 6, securely.
Short Caps
Screws
8. Open lid and lift the bagger assembly by the two center
arms of the frame. Carefully set the assembly onto the
mower, ensuring that the top pin on the frame lines up
with the hole on the adapter frame and the bottom pin
lines up with the hole in the bottom hitch of MPV. It
may be necessary to apply some pressure downward
so that the top of the frame is seated firmly onto the
adapter frame.
www.ravenamerica.com
D142100 R1 Bagger Manual_Final - English.indd 9
Long Hex Bolts
9. With the frame correctly mounted onto the MPV, locate
the large R Clip and insert into the hole at the end
of the top pin. A properly installed frame will look as
shown below.
R Clip Installed
10. Locate the upper and lower tubes and assemble them
together. Pull the Tube Strap on the bottom tube up
and onto the stud on the upper tube.
a
SSembly
9
4/9/2015 8:51:07 AM