Ewbank FP160 Guía De Cuidado página 7

Scrubbing /Cleaning the floor
• Ensure that the scrubbing brushes are
attached to the product (see page 5).
• Turn the machine on at the power socklet-
outlet.
• With your foot securing the head of the
polisher on the floor (1), pull the handle
towards you (2) and the machine will start
(Fig.8).
• Move the machine slowly across the surface
of the floor to loosen and collect any debris.
• Collect large debris towards the centre of the
base unit to prevent it from being spread
across the floor.
• Once this is complete, turn the machine off
before returning it to its upright position.
Polishing the floor
• Clean floor thoroughly first before adding
your chosen floor polish.
• Allow to dry before buffing using blue
buffing pads.
• With your foot securing the head of the
polisher on the floor, pull the handle towards
you and the machine will start (see Fig.8).
• If you are using a floor polishing wax or oil,
refer to the manufacturer's instructions when
using with the Ewbank
Polisher.
• Move at a speed of about 1 minute every 1m
and follow the diagram for an even finish
(Fig.7).
• Do not leave the machine operating in one
area for a prolonged period as this may
damage your floor.
Power Cord Storage
• The electrical power cord can be stored on
the rear of the product using the convenient
power cord storage hooks.
Floor Scrubber &
®
Fig.8
2.
Pull back
to start
2
7
1.
Place foot
on base