Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
WA R N I N G : V M F - E 2 H i s
designed for indoor use.
WARNING: check that the power
supply is disconnected before carrying
out any procedures on the unit.
WARNING: before carrying out
any work, put the proper individual
protection equipment on.
WARNING: the device must be
installed in compliance with national
plant engineering rules.
WA R N I N G : t h e e l e c t r i c a l
connections, plus the installation of
- Loosen the screws to remove the housing.
- Fit the panel (see figure).
ELECTRICAL WIRINGS
For all the connections, follow the
wiring diagrams.
The connections must be made with the
connectors on the electronic card on
the side of the fan coil (protected by a
plastic box).
12
AVMFE2H 1004 - 6795760_00
fan coils and relevant accessories,
should only be performed by a
technician with the necessary
technical and professional expertise to
install, modify, extend and maintain
systems, and who is able to check the
systems for purposes of safety and
correct operation (in this manual such
technicians will be indicated with the
general term "personnel with specific
technical skills").
In the specific case of electrical wirings,
the following must be checked:
- measurement of the electrical system
insulation strength.
- continuity of the protection wires
- Make all the connections.
- Reassemble the casing.
WARNING: the diagram showing
the connections of the electronic
card to the control board is printed
inside its box cover.
WARNING: Install a device, main
switch, or electric plug so you can
fully disconnect the device from the
power supply.
The essential indications to install the
device correctly are given here.
The installer's experience will be
necessary however, to perfect all the
operations in accordance with the
specific requirements.
The assembly site must be chosen in
such a way that the maximum and
minimum ambient temperature limits
are respected 0-45°C (<85% R.H.).
- Make sure the fan coil is working properly.
Publicidad
