AERMEC VMF-E4X Manual De Instrucciones página 10

CHOICE OF TEMPERATURE PROBE
The E4X panel allows the user to select, via a software parameter, the reference temperature probe for the adjustment of the E0/E1 thermostat.
Position of temperature probes
The figure shows an example of installation in which there is a fan coil (master) controlled by the E4 panel. In this case, the probes that detect
the room temperature are positioned on the panel and the fan coil.
To adjust the room temperature by means of the thermostat, one of the following three configurations can be selected.
SET OFF
+
To select the suitable configuration for the specific installation, just perform the three following operations:
AUTO
OFF
SET
SET OFF
AUX
+
+
1) hold the ( ) key down for 5 seconds, passing to the "choice of the type of regulation" mode;
AUTO
AUTO
AUX SET MODE OFF
AUX
SELECT +
2) Use the ( ) and ( ) keys to modify the type of regulation;
AUTO
MODE
MODE
SELECT
AUX
SELECT
3) Press the key ( ) to confirm the choice and go back to the "environment control" mode;
MODE
SELECT
Note: to use the area control and enabling of the pump by the centralised system (BMS or VMF-E5) this parameter must be set in C1 or C3
mode.
10
AVMFE4XLJ1120 - 6795769_02
Regulation with probe present on VMF-E4X;
Regulation with probe present on fancoil;
Regulation with average value between the two probes;
Adjustment with probe on board panel E4 without filtering software;
Adjustment with average value between the probe on board fan coils and value E4 probe without filtering
software;