Stihl RMA 443 VC Manual De Instrucciones página 46

français
pairs. Worn or damaged warning signs must
be replaced.
25.4 Handling
a) Only mow during the day or with good artificial
light.
b) If possible, avoid using the machine when the
grass is wet.
c) Always ensure good stability on slopes.
d) Operate the machine only at walking pace.
e) Only mow across and never up or down the
slope.
f) Be particularly careful when changing direction
on a slope.
g) Do not mow on excessively steep slopes.
h) Be particularly careful when turning the lawn
mower around or pulling it towards you.
i) Stop the cutting blade(s) when the machine
needs to be tilted for transportation over surfa-
ces other than grass and when moving the
lawn mower from and to the area to be mown.
j) Never use the lawn mower with damaged
safety devices or protective grilles or without
attached safety devices, e.g. deflectors and/or
grass-catching units.
k) Exercise care when starting or pressing the
starting switch and observe the manufacturer's
instructions. Ensure that you keep your feet far
enough away from the cutting blade(s).
l) The lawn mower must not be tilted when start-
ing it, unless the lawn mower needs to be lif-
ted during the process. In this case, only tilt it
as far as is absolutely necessary and only
raise the side facing away from the user.
m Do not start the motor when you are standing
in front of the discharge chute.
)
n) Never put hands or feet on or underneath
rotating parts. Always keep away from the dis-
charge opening.
o) Never lift or carry a lawn mower with the motor
running.
p) Stop the motor and pull out the starting key.
Ensure that all moving parts have come to a
complete stop:
- whenever you leave the lawn mower;
- before remedying blockages, including
those in the discharge chute;
- before checking, cleaning or working on the
lawn mower;
- after hitting a foreign object. Inspect the
lawn mower for damage and perform the
46
necessary repairs before re-starting and
using the lawn mower.
If the lawn mower begins to vibrate exces-
sively, it must be checked immediately.
- Check for damage;
- make the necessary repairs to damaged
parts;
- ensure that all screws, pins and bolts are
tightly fastened.
25.5 Maintenance and Storage
a) Ensure that all nuts, pins and bolts are tightly
fastened and that the machine is in a safe
working condition.
b) Check the grass-catching unit regularly for
wear or loss of functionality.
c) In the interests of safety, replace all worn or
damaged parts.
d) Be aware that on machines with more than
one cutting blade, the movement of one cut-
ting blade can cause the other cutting blade to
turn.
e) Ensure when adjusting the machine that your
fingers do not become pinched between mov-
ing cutting blades and stationary parts of the
machine.
f) Allow the motor to cool down before storing
the machine.
g) Note when maintaining the cutting blades that
the cutting blades can be moved even if the
power source is switched off.
h) In the interests of safety, replace all worn or
damaged parts. Only use genuine spare parts
and accessories.
Table des matières
1 Préface......................................................47
2 Informations concernant la présente Notice
d'emploi.....................................................47
3 Vue d'ensemble........................................ 48
4 Prescriptions de sécurité...........................49
5 Préparation de la tondeuse.......................55
6 Recharge de la batterie et DEL.................55
7 Assemblage de la tondeuse à gazon........56
8 Réglage de la tondeuse pour l'utilisateur.. 57
9 Introduction et extraction de la batterie.....57
10 Insertion et retrait de la clé de sécurité..... 58
11 Mise en marche et arrêt de la tondeuse à
gazon........................................................ 58
12 Contrôle de la tondeuse et de la batterie.. 59
13 Utilisation de la tondeuse..........................60
0478-131-9948-B