Route The Network Cable Through The Cable Hole - Axis P1355-E Guia De Instalacion

AXIS P1355-E/P1357-E Installation Guide

Route the network cable through the cable hole

1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
Cable gland
2. Remove the cap, the plug and the gasket from the cable gland that is to be used.
3. Route the network cable through the cap.
4. Slide the network cable through the slit on the gasket to attach the gasket to the network
cable. See Unit connectors, on page 15 for information on network cable requirements.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
Note:
Using any other than the provided cable gland may cause water to seep in and damage the
product. Cables must have a diameter of 4.0 mm - 5.5 mm.
Gasket
Plug (discard)
Cap
Page 9