Briteq COB SLIM 100-RGB Manual De Instrucciones página 11

ENGLISH
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.
 Press the [MODE] button until [DIMCURVE] is shown on the display.
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to selected the desired curve:
 Once you have the desired curve, press the [ENTER] button to save it.
FAN SPEED
Used to set behavior mode for the cooling fan.
 Press the [MODE] button until [FAN] is shown on the display.
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to selected the desired mode:
 [LOW]: The fan will always run at slow speed to avoid making noise. When the fixture gets too hot, the
light output will be dimmed
 [HIGH]: The fan will always run at full speed to have the best possible cooling
 [AUTO]: The fan will only run at full speed when the fixture gets too hot. Otherwise it will run at the
slowest possible speed to make less noise.
 Once you have the desired mode, press the [ENTER] button to save it.
LAMP BEHAVIOR
Used to select the reaction time of the projector.
 Press the [MODE] button until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 [LED]
 [HALOGEN]
 Once the correct option shows on the display, press the [ENTER] button to save it.
LOCKING MODE
Used to lock the setup menu against unwanted altering of the settings.
 Press the [MODE] button until the [LOCKING] is shown on the display.
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 [OFF]
The setup menu can be used at any time.
 [ON]
After a short time the setup menu locks automatically, the display shows [LOCKED *****].
Unlock the display by pressing the buttons in this order: UP, DOWN, UP, DOWN, ENTER.
 Once the correct option shows on the display, press the [ENTER] button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.
 Press the [MODE] button until [NO DMX] is shown on the display.
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 BLACKOUT
 FREEZE:
 Once the correct option shows on the display, press the [ENTER] button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
BRITEQ
®
The projector follows the instructions instantly, no delay.
The projector imitates the behavior of a halogen lamp (slower reaction time).
output turns black while no DMX is detected.
output based on the last valid DMX-signal is kept on the projector.
9/67
OPERATION MANUAL
COB SLIM100-RGB