Publicidad
Idiomas disponibles
Idiomas disponibles
4. LD3 and LD4 start flashing.
5. Release 'setup' when leds turn off.
This process takes about 10 seconds.
If the button is released before the leds turn off, the memory will not be cleared.
To set 'pulse'/ 'toggle' / 'timer' for each relay :
1. Push 'setup'-button repeatedly to select relay1 (output 1) or relay2 (output 2).
2. Confirm with a long push (LD4 flashes 3 times).
The selected relay will remain ON.
3. Push 'setup'-button repeatedly to select between pulse (LD3 : one flash) and toggle (LD3 : two flashes)
4. Confirm with a long push (LD4 flashes 3 times)
If you have selected 'toggle', the relay will turn off and your unit is ready for use.
For 'pulse' selection the setup continuous with timer selection.
5. Press 'setup'-button repeatedly to select the appropriate timer.
LD3 will flash 1..8 times, indicating the selected timer :
6. Confirm with a long push (LD4 flashes 3 times)
The relay will turn off and your unit is ready for use.
Repeat the process for the other relay.
Important : If you have made a mistake, you can return to normal operation by not operating any buttons for 10s.
Instructions
flashes
delay
1
pulse mode, no timer
2
5s
3
30s
4
1 minute
5
5 minutes
6
15 minutes
7
30 minutes
8
1 hour
7
Publicidad
