Safety Features - Twin Star Home SH-003-BL Manual De Usuario

Operation Instructions
The heater may be operated by the controls located on the heater .
1.Place the product upright on a flat, level, stable, heat-resistant surface, and then plug
the Power Cord into a standard 120-volt electrical outlet.
2.Main Control Knob: Use this knob to set the heat setting :
II • High heat seeting-1,500 W
I • Low heat setting -750 W
• Fan only ( no heat)
O • Off –Turn knob to "O" position, the appliance will be off.
3.Turn the Thermostat Control Knob clockwise to its maximum range. The
Power Indicator will illuminate, indicating the Heater is on.
4. Allow the product to operate until the ambient room temperature reaches the desired
comfort level.
5.Slowly turn the Thermostat Control Knob counter-clockwise until the product turns off.
The product will cycle on and off to maintain the setting.
6.To adjust the thermostat, turn the Thermostat Control Knob towards maximum to increase
the set ambient temperature and towards minimum to decrease it.
7.Turn off the product by rotating the Main Control Knob to the "OFF" position, and
then unplug the product from the electrical outlet.

SAFETY FEATURES:

1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the Heater will be automatically shut off.
It can only resume operation,when the user resets the unit.See reset instructions
below;
To Reset Heater:
a. Unplug the Heater and wait 15-20 minutes for the unit to cool down.
b. Then, turn on the unit again and operate normally.
3. The heater comes equipped with a safety tip over switch. It will cut off the power if
the appliance falles down.
A335
www.tsicustomerservice.com
5