Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING YOUR APPLIANCE
LOCATION
When selecting a position for your unit, ensure the floor is
a flat, level surface and the room is well ventilated. Avoid
locating your unit near a heat source, such as an oven, stove
top, boiler, or radiator. Also avoid direct sunlight as it may
increase the electrical consumption.
Extremely cold ambient temperatures may also prevent the
unit from operating effectively.. This unit is not designed
for use in a garage or outdoor installation. Do not place any
covering such as a drape or sheet on the unit.
When installing the unit, ensure that a minimum of 5 inches of
free space is left at both sides and in the rear, and 5 inches of
space at the top of the unit. This will allow cold air to circulate
around the refrigerator and improve the efficiency of the cool-
ing process.
LEVELING THE UNIT
It's very important to keep the unit level, so that the door
will close properly and prevent problem that will cause
effective cooling to fail. To level the unit, turn the four ad-
justable feet clockwise or counterclockwise to respectively
raise or lower the corner.
Tip: Having someone push against the top of the refrigera-
tor will take some weight off the leveling leg. This makes it
easier to adjust the leveling leg.
CLEANING BEFORE USE
Wipe the inside of the unit with a weak solution of baking
soda (bicarbonate). Then rinse with warm water using a
damp sponge or cloth. Wash the shelves and bins in warm
soapy water and dry completely before putting back in the
unit.
Note: This unit is shipped with a protective plastic covering
around the exterior. Remove completely before use.
POWER SUPPLY
• Be sure to plug in to 110V-120V (60Hz) grounded outlet.
• You must make sure all three prongs are in a 3-pronged
outlet (see note below).
• You may use extension cords only if they marked electri-
cal rating of the cord is at least as great as the rating of
this appliance, and is properly grounded as well.
• If using an extension cord, ensure that any excess does
not become a trip hazard.
Notes: When plugging in to wall, it should have a dedicated
outlet. (see Fig1. ).
If you only have a two-pronged outlet, adapters are avail-
able but must be used properly (see Fig.2 ).
When using a 3-pronged outlet
3-pronged
Receptacle
3-pronged
Receptacle
plug
Box Cover
Fig. 1
–2–
When using a grounding adapter,
make sure the receptacle box is fully
grounded.
Grounding Lead
Screw
Receptacle
Receptacle
Grounding
Box Cover
Adapter
Fig. 2
Publicidad
