Pool System Programming; User Menu - Aqua A- POOL SYSTEM PH-CL Manual De Instalación

Information concerning tubes
The suction tube must be as short as possible (1.5 m Max) and
installed vertically to keep air bubbles from being suctioned!
The delivery tube must be fixed in such a way that it does not move
unexpectedly thus causing it to break or damage objects nearby!
Use only tubes compatible with the chemical product to be dosed!
Consult the compatibility table. If the product is missing from the table,
consult the supplier!

3.0 Pool System Programming

The Pool System programming is divided into 2 menu: User Menu and Installation Menu
Press F to scroll User menu
Press Up-Down to change values
Press Enter to confirm setting values
Keep Pressed Enter to enter the Installation menu (password will be required)

3.1 User menu

User Menu is suitable for daily adjustment of Pool System settings.
It allows to:

Adjust pH set point (always inside the Proportional limit L1 see below Installation
menu)

Adjust Cl set point (always inside the Proportional limit L1 see below Installation
menu)

Display the quality of the pH probe measured with the last calibration (Only for
CONNECT version)

Make slide corrections of Chlorine reading. With DPD1 reading it could be done a
manual adjustment of system reading. The correct calibration of Pt-Cu electrode can
be done only under Installation menu. If the difference shown during adjustment is
higher than 20% it is recommended to proceed with complete calibration.

Make pumps priming (pressing Up and Down Button the pumps will work at 100%)
ADSP7000474 A-POOL SYSTEM PH-CL 11/04/2014 Rev.1.9 5/101