Atlantic WSM-S Manual De Operación página 2

Introduction:
Thank you for choosing Atlantic's Wall Spout. Wall Spouts are designed for use in
formal water feature applications utilizing an enclosed basin or open basin. They
can install easily into most retaining walls. The solid brass construction with oil
rubbed bronze finish will provide you with years of lasting enjoyment.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those
for which it is specified. Failure to observe these precautions can lead to
product failure or other problems.
• Follow all aspects of electrical codes installing the Wall Spouts. A grounding
lug is provided if required by code.
• Wall Spouts are designed for use in Pond-free, fountain applications, and
open basins of water.
Installation
Use 1½" plumbing to feed each Wall
Spout. The required flow rate of each
spout is 600 gph. The first thing to
consider when plumbing the wall
spout is whether or not to light the
water from behind. When plumbing
without a light, a simple 1½" PVC
elbow is required (see Figure 1). If
you plan to plumb a light at the back
of the wall, a 1½" tee with a 1½"x 1"
female threaded bushing should
be used (see Figure 2).
Apply teflon tape or paste on the
threads, then thread the 1½" Male
Thread Adapter (MTA) into the back of
the spout (see Figure 3). The MTA will
recess into the wall in order to mount
the back plate flush against the wall.
When possible, dry fit the 1½" PVC
pipe through the wall, and cut
the pipe to the desired
length. If this is not
possible, leave enough
room in the wall to glue
the MTA to the pipe.
2
Figure 1
1½"
elbow
Figure 2
1½" tee
1½" x 1"
bushing