Operation Instructions - PUR P2QC8506BLS Manual Del Propietário

Initial Product Cleaning (continued):
9. To drain any remaining water from the reservoirs, unscrew the drain cap and
plug located at the rear of the dispenser (Figure 17). Collect the water into a
bucket. Flush the reservoir a second time with clean water.
IMPORTANT: Remember to re-install and tighten the drain cap and the plug.
10. Re-install the reservoir cover by pressing down firmly.
11. Re-install the dispenser top cover and secure using the two Phillips screws.
12. Re-connect the power cord.
13. Re-open the manual shut-off valve. You will hear water entering the system
which will stop automatically when the appropriate water levels are reached.
14. Place a container under the water dispensing spigot and press both
dispensing buttons (separately) to make sure water is flowing normally.

Operation Instructions:

IMPORTANT NOTE: Your PUR
mechanism) that controls the operation of the hot water tank heating system.
If no water is present and/or low water levels are detected inside the internal reservoir system, operation of the hot water heating
system is not possible. Likewise, if the hot water heating is operational and water is being drawn simultaneously causing water levels
to drop below safe levels, hot water tank operation is automatically terminated until normal water levels are restored.
NOTE: Operation of the cold water system is not affected by this safety feature.
Dispensing Hot Water (See Figure 18 & 19):
CAUTION: Do not allow children to use the hot water dispensing button
without proper and direct supervision.
To prevent hot water from being dispensed accidentally and possibly harming a child,
the hot water dispensing button can only be operated when the child resistant safety
switch is activated. To dispense hot water, push in the child resistant safety switch
(Figure 18), then press/hold the hot water button (Figure 19). Upon releasing the hot
water button, the child safety switch automatically re-engages to the locked position.
WARNING: The hot water is heated to approximately 90°C (194°F).
Temperatures above 52°C (125°F) can cause severe burns from scalding.
NOTE: The hot water temperature (factory default setting) is not adjustable
on this unit.
Water Dispenser is designed with a special safety feature (float switch
®
Figure 16
Figure 17
Figure 18
Figure 19
8