Vinobox 24 Design Manual De Uso página 9

The LED display will show the setting temperature when "flash"; Display will
show the temperature for the wine cooler when normal .
7 ℃ ℉ Display /
8 Set temperature
press this bottom, press
temperature at any time, touch the UP or DOWN mark, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds.
9 ℉/℃ Selector
Select the temperature display setting in Fahrenheit or Celsius degree.
10 Light
To control the inner light turn on/off.
Setting the Temperature Control
You can select temperature display setting from Fahrenheit to Celsius degree b
touching the ℃ ℉ Selector mark. Fahrenheit or Celsius degrees indicator will appear /
in blue color in the temperature display window for each zone. You can set the
temperature as you desire by touching the UP and DOWN marks. When you touch the
two marks for the first time, the LED readout will show the original temperature set
previously.
 The temperature that you desire to set will increase 1 ℃or 1 ℉ if you touch the
UP mark once, on the contrary the temperature will decrease 1 ℃or 1℉ if you
touch the DOWN mark once.
 Temperature range : 5-18℃/41-64℉,
 The temperature inside the unit will be appeared in blue color in the display
window.
Shelves
 To prevent damaging the door gasket, make sure the door is fully open when
pulling shelves out of the rail compartment.
 For easy access to the bottles stored, pull the shelves out approximately 1/3.The
shelves are designed with an emergency stop to prevent the being removed too far
when loaded.
 The shelves has been designed so that a range of shelf height can be selected. All
the shelves can be adjusted.
Defrosting
to set temperature. To view the "set"