Power Source; Basic Operation; Battery Back Up; Setting The Clock - Ricatech RR3100 Manual Del Usuario

POWER SOURCE

1. unwind the AC power cord at the back of unit and connect it to power adaptor AC inlet.
2. The power adaptor dc cord connect to main unit of the DC INPUT JACK.
3. Connect the AC power cord to the wall socket.
POWER UP YOUR UNIT
This system switches to Standby mode automatically and LCD would shown as below
To switch the unit on, press POWER /
STANDBY LED is turned off and displayed as below.

BASIC OPERATION

Function select
1. Press FUNCTION /
2. When the set is on, press POWER /
message―GOOD BYE‖ for 2 seconds, then the STANDBY LED is turned on.
Note: In the standby mode, the tone, sound settings, tuner presets and the volume level (up to a maximum volume
level of 30) will be stored in the unit's memory.

BATTERY BACK UP

The battery backup system to maintain your clock and alarm settings during a power outage. In the event of a power
outage, the battery backup will save your time and alarm settings until power is restored. To utilize the battery backup, you
must install two AAA batteries. The battery backup will not operate unless batteries are installed. To install batteries, follow
the instructions below.
1 Remove the Battery Compartment cover from the back of the unit.
2 Install two new AAA batteries in the correct position as shown inside the battery cover.
3 Reinstall the Battery Compartment cover.
NOTE:
Do not use different batteries
Do not mix old and new batteries

Setting the clock

After connecting the system to power supply, set the clock first.
1. Press POWER /
- The display shows the time
―0:00‖ flashes by default if you have not set the clock
-
2 In the Standby mode, press and hold PROGRAM /
LCD backlight will be turned on.
to select among:
to switch the unit off. LCD backlight will be turned off and shown
to switch the unit to Standby mode
over 1 second.