American Woodmark Corporation SGH36U Manual Del Usuario página 3

Installation Instructions
Stem Glass Holder
TO MOUNT TO 24" WIDE WALL CABINETS:
Place Stem Glass Holder unit on flat surface with the mounting strips facing up.
1
Using the screwdriver, remove the first four rails and replace the first (smaller) rail
where the fourth rail was. With pencil, mark each end of both mounting strips.
See Figure 3.
Cut each end of mounting strips off, using marks as guides.
2
Center SGH36U unit under your Wall Cabinet by using the two horizontal
3
mounting strips as guides.
Using pre-drilled holes in mounting strips, pilot drill 1/8" diameter holes to a
4
depth of 3/8" and fasten to the bottom of the cabinet with #8 X 1" Phillips
screws.
TO MOUNT TO 18" WIDE WALL CABINETS:
Place Stem Glass Holder unit on flat surface with the mounting strips facing up.
1
Using the screwdriver, remove the first five rails and replace the first (smaller) rail
where the fifth rail was. With pencil, mark each end of both mounting strips as
shown. See Figure 4.
Cut each end of mounting strips off using marks as guides.
2
Center SGH36U unit under your Wall Cabinet by using the two horizontal
3
mounting strips as guides.
Holding the unit in place, pilot drill 1/8" diameter holes through each straight
4
vertical pre-drilled hole in mounting strips to a depth of 3/8" and fasten to the
bottom of the cabinet with #8 x 1" Phillips screws.
continued
11-7/8"
Figure 3
16-13/16"
Figure 4
1/8"
1-3/16"
99883 5/08