Westinghouse LTB40 Manual Del Usuario página 9

SAFETY INFORMATION
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off when you turn
out the lights.
c. Move charger and battery pack to a location where the surrounding air temperature is
approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were
easily done previously. DO NOT CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever you desire with no adverse affect
on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or
any buildup of metallic particles should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the cavity. Unplug charger before
attempting to clean.
6. Do not freeze or immerse the charger in water or any other liquid.
WARNING: Do not allow any liquid to get inside charger. Never attempt to open the battery pack
for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center
for recycling.
FEATURES
Description of the parts
1. On/Off Trigger
2. Rear Handle
3. Starter Button
4. Handle
5. Upper Shaft
6. Shaft Coupler
7. Lower Shaft
8. Trimmer Guard
9. Adjustable Cutting Diameter
10. Cutting Line
11. Edger Button
12. Edger wheel
13. Battery Interlock
2
3
4
5
6
7
11
12
8
10
9
13
1
This product can accept any of the batteries and char-
gers listed in the chart below:
Westinghouse 40V Lithium-Ion Packs and Chargers
Description
40V Batteries: LI-ION
Chargers
Part number
LBA40120, LBA40125,
LBA40240
CGA402
9