Angelo Po Combi-Duo 6x1/1 GN Instrucciones De Instalación Y Gráficos página 8

GB
Combi-Duo with legs:
- Fit upper part of the leg together with the
reinforcement plate to the bottom of the unit.
- Screw in the lower part of the leg of the kit.
Attention:
Use original lower part of the legs when
putting Combi-Duo 6x1/1GN / 6x1/1GN on a
stand.
Combi-Duo with legs on mobile stand
(only 6x1/1 GN / 6x1/1 GN resp.. 6x2/1 GN / 6x2/1 GN)
- Fit upper part of the leg together with the
reinforcement plate to the bottom of the unit.
- At the left rear leg additionally fit the safety
bracket between upper part of the leg and
reinforcement plate. This safety bracket can be
used to secure the unit against movement.
- Fit the 4 leg brackets of the mobile stand to
the lower part of the unit legs.
- Screw lower part of the legs into upper parts.
- Put unit onto mobile stand and fasten it with
the leg brackets to the mobile stand
- Level the unit at the site
- Fit water hose to the unit and check for
leakage.
- Remove dome.
- Clean top cover with a wet cloth.
- Remove screws of top cover at positions where
openings in the stiffening plate are (are used for
fixing stiffening plate).
- The stiffening plate is prepared for units with
right hinged doors. If it shall be used on units
with left hinged doors, then the corresponding
knock out of the door holding angle must be
removed.
- The cover clima valve (pos. 8) is fixed to the
stiffening plate with a safety nut. Remove this
nut
V08
- Put stiffening plate (Pos. 1) onto the unit. pic. 10
- Tighten stiffening plate with the screws removed
from top cover.
pic. 5/6 - Fix clima valve with screw (pos. 7), cover (pos. 8)
and gasket (pos. 9) to stiffening plate (screw,
cover and gasket replace dome).
Attention:
Make sure that the clima valve is not
blocked by the screw and that there is no
visible gap between clima valve and inner
side of the unit top cover .
- Put gasket ventilation pipe (pos. 2) over the pipe.
pic. 5/6
- Fit exhaust air chamber (pos. 3) to the stiffening
plate and install gasket exhaust pipe (pos. 4)
into it.
- Remove door handle and install it up side down,
pic. 18 item A by:
- Removing plastic cover of door lock.
pic. 17 (Push cover to inner side of the door and pull
it out)
- Loosen allen screw (5 mm) of door handle.
pic 18 - Pull of door handle and turn it up side down.
- Refit door handle
pic. 8 - Install plastic cover
pic. 9
pic. 10
- 8 -
pic 10
pic. 11
pic. 11