Madas EVP/NC Manual Del Usario página 20

5.2 - REPLACING THE COIL
I) Fastening nut
Remove the fastening ring nut (20)
with a 35mm commercial spanner
m
Now proceed with replacing the coil
p
Remove the washer (II) Insert the new coil and position the
s
• On completion of the above operations, proceed with wiring the coil just installed, as shown in 3.2
EVP/NC - EVPF/NC
a
II) Washer
n
Loosen the nut (I) with a 35mm
q
t
III) Threaded bar
Remove the O-Ring (19)
commercial spanner
O-Ring
20
Madas Technical Manual - REV. 0 of 10
Complete coil
(including connector/board)
supplied as a spare part
Extract and remove the coil (4)
o
Remove the coil from the threaded
bar (III)
r
Tighten and secure the fastening
ring nut again with a 35 mm
commercial spanner
u
May 2018
th