Technical Data; Hydraulic Connection; Installation Declaration; Manual Suction Hose Attachment (Ex-Factory) - Kärcher MC 250 Implementos

1.7.7 Technical data

Hydraulic connection

Supply from the hydraulic system of the MC 250
Connection output
Water connection
Water supply from the fresh water tank of the MC 250
Input temperature (max.)
Performance data
Working pressure
Nozzle size
Max. operating pressure
Flow rate
Recoil force of the trigger gun. (max.) N
Determined values according to EN 60335-2-79
Sound level K
pA
Uncertainty K
pA
Sound power level L + uncertainty
WA
K
WA
Hand-arm vibration value
Uncertainty K
Operating materials
Oil volume
Oil type

1.7.8 Installation declaration

We hereby declare die technical documents according to
EC Directive 2006/42/EC (+2009/127/EC) Annex VII Part
B have been created for the incomplete machine de-
scribed below and that this conforms to the following points
of the directive:
Annex I Points 1.1, 1.2, 1.3, 1.4, 1.5, 1.6 and 1.7. I Point
1.1,
This declaration is invalidated by any changes made to the
incomplete machine that are not approved by us.
Product:
Type:
Harmonised standards used, based on:
EN 60335–2–79
Authorities can request the relevant documentation for the
incomplete machine from the documentation supervisor.
Documents are provided via email.
Before commissioning or installation of the incomplete ma-
chine, it must be ensured that the complete machine into
which the incomplete machine is installed conforms to the
EC Machinery Directive 2006/42/EC (+2009/127/EC).
Please refer to the EC Declaration of Conformity for the
machine for more information on this.
The signatories act on behalf of and with the authority of
the company management.
H. Jenner
Chairman of the Board of Management
Documentation supervisor:
S. Reiser
kW 4.5
°C 60
MPa 7-15
036
MPa 19
l/min 10
30
dB(A) 75
dB(A) 3
dB(A) 97
2
m/s 1.6
2
m/s 0.7
l 0.4
SAE 15W-
40
Attachment kit
High-pressure cleaner
2,852-757.7
S. Reiser
Director Regulatory Affairs & Certification
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2019/11/01
1.8 Manual suction hose attachment (ex-
factory)
The manual suction hose is included in the scope of deliv-
ery when ordered ex-factory.
Manual suction hose
1
Manual suction pipe
2
Clamp lock belt
3
Locking wedge
4
Lynch pin
5
Locking hook
6
 Removing the attachment from the vehicle
The attachment can be easily removed if not required.
To remove, pull out the lynch pin and open both locking
wedges. Then remove the attachment with 2 people.
 Pivoting the attachment to the side
The attachment must be pivoted completely outwards in
order to empty the waste container.
To do this, open both locking wedges and pivot the at-
tachment all the way out to the side wall, where it is held
by a magnet. Push the locking hook upwards before piv-
oting back.

1.8.1 Working with the manual suction hose

The vehicle is parked and the travel direction selector
switch is in the NEUTRAL position (middle position).
Bottom rubber flaps position
1
Note
Working with the manual suction hose
Air intake opening
2
English 37