Control Panel; Filter Replacement - TruSens Z-3000 Manual De Usario

IMPORTANT: Before operation of the purifier, follow the steps and
read our TruSens Owners Guide at: www.trusens.com/Z-3000
Set up
Fig. 1)
Unscrew bottom cover and remove plastic bag from
filter
Fig. 2)
Secure filter on bottom cover and replace inside the
purifier

Control panel

Fig. 4)
Power on/off
Fan speed: Auto/Whisper/1/2/3/Turbo
Dimmer on/off
Timer: 2h/4h/8h/12h
UV mode on/off
Carbon/HEPA/UV replacements

Filter Replacement

Fig. 5)
Filter type
A. Washable Prefilter
B. Carbon filter
C. HEPA Drum Filter
D. UV Bulb
#
*Replacements indicator will glow red on control panel to notify you to change.
See Fig. 6) Use caution when using a screwdriver to remove the UV housing when replacing the UV-C emitter.
#
Suggested Replacement / Cleaning
Hand wash as needed with water
Every 3-4 months*
Every 12-15 months*
Every 2-3 years*
Fig. 3)
Plug-in your purifier and power on
Plug-in your SensorPod
TM
For optimal results, place SensorPod
counter across the room, within line sight of the purifier
Signal strength may vary by location
Room coverage up to 70 m²
0 - 50, Blue / Good
50 - 100, Yellow / Moderate
100+, Red / Poor
SensorPod signal indicator
TM
Item Number
Not sold separately, see HEPA Drum Filter
2415109 (3-pack)
2415110 (includes A, B & C)
2415111
EN
on tabletop or
TM
Page 5