Technical Data - Mesko MS7804 Manual De Uso

sink filled with water.
15. The heater should be placed on a level, heat-resistant surface, away (at least one
meter) from flammable materials (lace curtains, curtains, wallpaper, furniture etc.).
16. The power cable should not be placed above the heater, and also should not touch or
lie close to hot surfaces. Do not place the heater under an electrical outlet.
17. The surface of the heater can heat up to high temperatures of over 60 degrees C. Take
care when near the heater.
18. Do not cover the heater with curtains, a towel or hang washing on it – this can damage
the heater or cause a fire.
19. When using the heater, completely unwind its cable and make sure that the cable is not
touching the hot surface of the heater.
20. Do not use the heater near basins, showers, sinks, pools or other places where it can
get wet.
21. The device must be completely cool prior to storage. Keep the original packaging to
store the heater in during non-heating seasons.
22. The heater is filled with a set amount of special oil. Repairs requiring opening of the oil
container must be carried out only by the manufacturer or authorized representative, who
should be contacted if oil leaks from the heater.
23. If disposing of the heater please follow rules of oil disposal.
WARNING: To avoid overheating do not cover the heater.
DESCRIPTION OF THE DEVICE (Fig. 1)
1. On/Off switch
2. Thermostat control knob
3. Ribs
USING THE DEVICE
CAUTION: During first use of the heater a small amount of smoke may appear. This is normal.
1. Place the oil heater a minimum of 100 cm from walls, furniture, curtains, plants etc.
2. Connect the oil heater to mains power.
3. Turn the heater on by he switch (1). Set a comfortable oil heater temperature by turning the thermostat control knob.
4. After you finish using the heater, turn it off by turning the on-switch and thermostat control knob to 'OFF' and disconnect the power
cable from mains power.
CLEANING THE DEVICE
1. Prior to cleaning always remove the plug from the electrical outlet.
2. Prior to cleaning allow the heater to cool. Make sure that it is cool.
3. Wipe the heater with a damp cloth, then wipe dry.
4. Never use wax, shining agents or chemical agents to clean the heater. They may react with the device and cause discoloration or
even damage.

TECHNICAL DATA

Power source: 220-240V~50/60 Hz
Power:
MS7804 – 700 W
MS7805 – 1000 W
Ms7806 – 1200 W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the
environment. Electrical appliance must be returned in order to reduce its reuse and utilization. If the device contains batteries
they should be delivered to dedicated points separatelly.
Device is made in class I of insulation and has to be
connected only to power outlet with ground circuit.
Device is compliant with EU directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
6