EarthWise TC70040 Manual Del Operador página 7

Tines are identified (A,B,C,D) with letters stamped into the Tine Hubs.
DANGER: Before adjusting tine assembly, make sure the battery is removed from the battery compartment
and the switch key is removed. Failure to heed this warning could result in serious personal injury.
CHANGE FROM FOUR TINES TO TWO TINES
Lift the Lock Pin rings and remove Lock Pins at
both ends of the shaft. Remove Tine A and D from
the shaft. (Fig. 3)
CHANGE FROM TWO TINES TO FOUR TINES
Install Tine A and D onto the shaft as shown.
Ensure holes in Tine Hubs and shaft are aligned.
Insert Lock Pin into the through holes and pull
Lock pin ring downward to lock the Pin into place.
Be sure to install Tines as shown in Fig 3. Tines
cannot be secured if assembled in other sequence
of Tine position. (Fig. 3)
ADJUSTABLE TINE ASSEMBLY INSTRUCTION
In the event the lock Pins are lost or misplaced,
Tines A and D may be secured using the extra
M8X40 Hex head bolts and M8 Lock nuts
provided. (Fig. 4)
7