Setup And Configuration - Leviton omnistat 3 Instrucciones De Instalación

4-Pipe - Continued
Connect to Pipe
Temperature
Sensor

SETUP AND CONFIGURATION

Installation Settings
This section describes the items that the installer must set up as part of the thermostat
installation. The Installation Settings menu is used to configure the operating
parameters of the thermostat. The Menu button is hidden from view on the faceplate of
the thermostat to prevent unauthorized guest access – it is located immediately to the
right of the C/F button.
To access the Installation Settings mode:
1. From the main display, tap the Menu button (hidden) 3 times - See Figure 13.
2. At the Enter Passcode display, use the icons below the display to increment the
associated value in the passcode and then press the Menu button. Values 0000-
9999 can be set. CRITICAL NOTE: The thermostat ships from the factory with
no passcode set. Upon first access, "Create Passcode" will be displayed.
The installer must set a passcode, then press the Menu button, and then
confirm the passcode by re-entering it and pressing the Menu button again.
Connections to a Remote Temperature Sensor
Menu Button Location
Figure 12
J4
Figure 13
19