Descargar Imprimir esta página

bloom coco go lounger Guia Del Usuario página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
To assemble
– Press button on the base of each support arm
and rotate the two support arms on the base
outwards until each is locked in its vertical
position. You will hear an audible click on
each side. (refer to illustration 7)
– Position seat frame over the base aligning the
frame's locking mechanisms with the support
arm connectors. On the base, the side with
support arms is the rear end of coco go.
Press the frame's locking mechanisms into
the connector's receptacles. You will hear an
audible click on each side. (refer to illustration
8)
Remark: Before attaching the seat frame,
make sure the slide button on both side of
seat frame is pushed forward.
– Check the locks are securely engaged by
lifting the seat frame.
The coco go lounger offer three
different configuration: feeding,
bouncer and rocker mode.
Rocker mode – suitable for newborn to 6
months
– In rocker mode, the seat frame can be
adjusted in three different recline positions.
– Make sure all four stoppers located
underneath the ends of the wooden slate are
folded in. (refer to illustration 10)
– On the underside of vibrating unit, pull out
clasp and hook onto the front rod of base.
(refer to illustration 11)
Bouncer mode – suitable for newborn to 6
months
– In bouncer mode, the seat frame can be
adjusted in 2 different recline positions.
– Located underneath the ends of the wooden
slate, rotate all four stoppers outwards. (refer
to illustration 13)
– Press the two buttons on the connector
simultaneously and rotate seat frame to your
desired angle. You will hear audible clicks as
the seat locks into position. (refer to illustration
14)
Sitting mode – suitable for 6-12 months of age
– Located underneath the ends of the wooden
slate, rotate all four stoppers outwards. (refer
to illustration 15)
– Press the two buttons on the connector
simultaneously and rotate seat frame to the
first upright position.
– On the underside of vibrating unit, pull out
clasp and hook onto the front rod of base.
(refer to illustration 16)
Remark: To release the clasp from the front rod
of base, press the two buttons on both side of
the clasp simultaneously and then pull out.
To install batteries
– On the vibration unit, remove the battery cover
by loosening the screws with a philips head
screwdriver. (refer to illustration 18)
– Install two AA batteries (not included) into the
unit. Make sure the batteries are in correct
orientation, following the markings in the
eng
13

Publicidad

loading