MTD 19A30003OEM Manual Del Operador página 13

Figure 4-20
12. Install a grass-catcher pin (911-04069) from hardware pack
689-00092B into the hole provided in the upper portion of the
chute elbow and secure with a flange lock nut (712-3027). See
Fig. 4-21.
Figure 4-21
13. Install the other rubber strap onto the chute tube extension
using the remaining clevis pin, flat washer and bow-tie cotter
pin from hardware pack 689-00092B. Attach the end with the
hole closest to the end of the strap, as seen in Fig. 4-22. This
will make it easier to grab onto the strap to pull, stretch and
hook onto the grass-catcher pin previously installed on the
chute elbow in the previous step.
14. With the tractor's discharge chute raised up and held open,
install the chute elbow over the chute opening by placing
the deck mounting pin in the hole provided, as seen in
Fig. 4-23, then secure the elbow to the deck by hooking
the retainer strap torsion spring hook over the deck wheel
mounting bracket a seen in Fig. 4-24.
Note: On decks without deck wheels, hook the retainer
strap into the hole provided in the flange on the front-side
of the cutting deck.
Figure 4-22
Figure 4-23
Figure 4-24
s 4 — a & i
ectiOn sseMbly nstallatiOn
13