Cleaning The Filter; Fig. 18 - Kaz EFY-041 Serie Manual Del Propietário

EFY-045 SERIES, EFY-047, HY-047 AND HY-048 SERIES REMOTE CONTROL OPERATION (CONT'D)
Flashlight Feature:
Note: Only one bulb will activate when using the flashlight feature. The Remote Control
has only one light. The second bulb is the Remote Transmitter.
Press and hold the Flashlight button (
activate the Flashlight.
Remote Control Storage
The remote control may be stored in the recessed area located behind the bezel
controls when it is not in use.
CLEANING AND STORAGE EFY-041, HY-041, EFY-047, HY-047 AND HY-048 SERIES
A. CLEANING THE FILTER
Note: The filter feature is only available on the EFY-041 Series, EFY-047 Series,
HY-041 Series, HY-047 Series, and HY-048 Series. The EFY-045 Series does not have
this feature.
The filter is located behind the rear grille of the fan. To clean the filter:
• Be sure the fan is turned off and the power cord in unplugged
from the outlet.
• Gently unsnap the rear grille from the fan (Fig. 18) and remove
the filter.
• Run the filter under cool water to remove the accumulation
of particles.
• Once filter has been cleaned let it dry completely before placing
back in fan. Do not wring, bend or pull on the filter as this may cause damage.
• Once the filter is completely dry, replace the filter and firmly snap rear
grille cover back in place.
B. CLEANING THE FAN
• Ensure the fan is turned off and unplugged.
• Use only a soft cloth to gently wipe the outer surfaces
of the fan clean.
• To clean between the grilles and fan blade area, we recommend
using a pipe cleaner, flexible dustwand, vacuum cleaner or
compressed air to gently remove the dust.
• To clean the rear grille use a soft dry cloth. Once the rear grille
is clean replace filter and rear grille before operating. (Fig. 19)
This fan is equipped with a safety "OFF" switch to prevent the fan
from operating if the rear grille is removed or not properly assembled.
• DO NOT immerse the fan in water and never allow water to drip into
the motor housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
• For storage, you may leave the fan assembled and covered to protect it
from dust. Store the fan in a cool, dry place.
) located on the back of the remote control to

Fig. 18

Fig. 19
Filter
Grille