KENMORE ELITE 116.21814 Manual De Uso Y Cuidado página 9

CANISTER
1. Open the canister hood.
2. Check to see that the dust bag is
properly installed. See BAG CHANGING
(page 19) for instructions.
3. Check to see that the motor safety filter
is properly installed. See MOTOR SAFETY
FILTERCHANGING (page 20) for
instructions.
HOOD AND TOOL STORAGE
COVER
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed.
TO REINSTALLTOOL STORAGE COVER:
1. Press tool storage cover bracket down.
Storage
Cover Bracket
2. Align front edges of tool storage cover
on canister hood.
3. Press rear of tool storage cover clown
until it snaps into place.
TO REINSTALL HOOD:
1. Lift hood bracket up as shown.
2. Insert tab located on the hood with slot
located on the hood bracket.
H(
Bracket
3. Lower hood
to close. The
hood will snap
into bracket as
the hood is
lowered.
HOSE
1. Line up the hose
latch tab and
notch in canister
hood and insert
hose into canister
until it snaps into
place.
IMPORTANT:
Pushhose connector firmly into the cansiter
body until the hose latch tab snaps into
place. The vacuum cleaner will not operate
until hose is fully connected.
To remove: Do not open hood before
removing hose. With hood closed, press
hose latch tab and remove hose.
-g-