Safety Devices; Feather Board; Push Stick; Filler Piece - WMH Tool Group JET 708315BTA Instrucciones De Operación Y Manual De Repuestos

Figure 39

Safety Devices

Feath r Board
e
The feather board (Figure 40) should be made
of straight grain hardwood approximately 1" thick
and 4" to 8" wide depending on the size of the
machine. The length is developed in accordance
with intended use. Feather boards can be
fastened to the table or rip fence by use of
C-clamps. If this method of fastening is used,
provide slots in the feather board for adjustment.
(The illustration shows a method of attaching
and use of the feather board as a vertical comb.
The horizontal application is essentially the
same except that the attachment is to the table
top.)
Figure 40

Push Stick

A push stick is provided with this saw and
should be used as an added level of safety for
the operator.

Filler Piece

A filler piece (Figure 41) is necessary for narrow
ripping and permits the blade guard to remain on
the machine. It also provides space for the safe
use of a push stick.
Figure 41 – Filler Piece

Maintenance

Always disconnect power to
the machine before performing maintenance.
Failure to do this may result in serious
personal injury.

Cleaning

Clean the 708315 Table Saw according to the
schedule below
performance.
Note: The following maintenance schedule
assumes the saw is being used every day.
Daily:
Clean pitch and resin from the saw blade.
Weekly:
Clean motor housing with compressed air.
Wipe down the table surface, grooves and
fence rails with a dry silicon lubricant.
26
to ensure maximum